CVE alerts for
macOS

In the Linux kernel, the following vulnerability has been resolved: ALSA: firewire: isight: bound the sample count to the packet payload isight_packet() takes the frame count from the device iso packet and checks it only against the device claimed iso length. count = be32_to_cpu(payload->sample_count); if (likely(count <= (length - 16) / 4)) isight_samples(isight, payload->samples, count); length is the iso header data_length. It can be up to 0xffff. So the gate allows a count up to about 16379. isight_samples() then copies count frames out of payload->samples into the PCM DMA buffer. payload->samples holds only 2 * MAX_FRAMES_PER_PACKET values. The device multiplexes two samples per frame. A count past MAX_FRAMES_PER_PACKET reads past the payload. A count past the buffer size writes past runtime->dma_area. The smallest PCM buffer is larger than MAX_FRAMES_PER_PACKET. Bounding the count to MAX_FRAMES_PER_PACKET keeps both the read and the write in range. A malicious or faulty Apple iSight on the FireWire bus reaches this during a normal capture. Add the MAX_FRAMES_PER_PACKET bound to the gate.

In the Linux kernel, the following vulnerability has been resolved: HID: appleir: fix UAF on pending key_up_timer in remove() appleir_remove() runs hid_hw_stop() before timer_delete_sync(). hid_hw_stop() synchronously unregisters the HID input device via hid_disconnect() -> hidinput_disconnect() -> input_unregister_device(), which drops the last reference and frees the underlying input_dev when no userspace handle holds it open. key_up_tick() reads appleir->input_dev and calls input_report_key() / input_sync() on it. The timer is armed from appleir_raw_event() with a HZ/8 (~125 ms) timeout on every keydown and key-repeat report. If a key was pressed shortly before the device is disconnected, the timer can fire after hid_hw_stop() has freed input_dev but before the teardown drains it. A simple reorder is not sufficient. Putting the timer drain first still leaves a window where a USB URB completion (raw_event) running during hid_hw_stop() can call mod_timer() and re-arm the timer, which then fires after hidinput_disconnect() has freed input_dev. The same URB-completion window also lets raw_event() reach key_up(), key_down() and battery_flat() directly, all of which dereference appleir->input_dev. Introduce a 'removing' flag on struct appleir, gated by the existing spinlock. appleir_remove() sets the flag under the lock and then shuts down the timer with timer_shutdown_sync(), which both drains any in-flight callback and permanently disables further mod_timer() calls. appleir_raw_event() and key_up_tick() bail out early if the flag is set, so no path can arm or run the timer, or dereference appleir->input_dev, after remove() has started tearing down. The keyrepeat and flatbattery branches of appleir_raw_event() previously called into the input layer without holding the spinlock; take it now so the flag check is well-defined. This incidentally closes a pre-existing read-side race on appleir->current_key in the keyrepeat branch. This bug is structurally a sibling of commit 4db2af929279 ("HID: appletb-kbd: fix UAF in inactivity-timer cleanup path") and has been present since the driver was introduced.